![]() ![]() It can be used almost anywhere to represent any feature of size. When you have a hole in a part such as a bolt pattern, true position is usually called out. However, this can also be applied to any feature of size in need of a location tolerance, such as a pin, a boss, or even a keyway. In the image below you can see how a hole is called out using the position tolerance symbol. Position can be used with Max Material Condition ( MMC), Least Material Condition ( LMC), projected tolerances, and tangent planes. Locating surfaces is to be controlled via Profile. See the above central elements of a hole, slot and sphere. Position may be applied to any feature of size (Feature with physical dimensions like a hole, slot, boss, tab, or sphere) and control the central elements of these size features. For clarity on these two terms check out our article and video here. However, it is correctly termed in the ASME Y14.5 standard as simply “Position”. Application:Īlthough incorrect, we title this page and sometimes refer to the symbol as “True Position” since this is typically the term people are referencing when they are looking for the position tolerance. However, since this is such a useful symbol, we will continue to add content and examples for other uses of this nifty little symbol in the coming months. ![]() The two methods of using Position discussed on this page will be RFS or Regardless of Feature Size and under a material condition ( Maximum Material Condition or Least Material Condition). Position is one of the most useful and most complex of all the symbols in GD&T. In other words, the Geometric Dimensioning and Tolerancing “Position” tolerance is how far your feature’s location can vary from its “True Position”. The “ True Position” is the exact coordinate, or location defined by basic dimensions or other means that represents the nominal value. True Position, or just Position as the ASME Y14.5 standard calls it, is defined as the total permissible variation that a feature can have from its “true” position.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |